Monitors battery status for Eaton 5P-550. Timothy Loput of the Beaverton School District submitted this probe as part of the 2017 Intermapper probes contest.

Josh Marsh from Gresham-Barlow School District in Gresham OR, sends a probe to provide basic monitoring for the Minuteman UPS SNMP-Net interface card. It shows basic info, load, temperature, and time remaining. The probe also supports much larger UPSes, so designing the output to only show the valid info was interesting. There was also some work that needed to be done on formatting, due to output...

Reports status conditions for APC Silcon UPS. It's geared for a three-module N+1 setup on 208v power, and warns about load when you are in danger of going out of redundancy (as opposed to reaching the one-module tolerances), but the thresholds are fully adjustable.

Monitors Sentry 3 CDU. This probe is based on two infeeds, each with two branches (AA, AB, BA, BB) and does give false alarms for CDUs with one infeed (AA, AB) since it can't communicate with the B tower.

Monitors 3-phase APC rack-mount PDUs. The probe checks all three phases for load plus current for each of the individual phases. Warning, alarm and critical thresholds can be set for current.

Monitors an MGE "Pulsar EXL5" UPS with a UM-Link Ethernet interface via SNMP. (Note: The probe can be used as a starting point for the design of similar probes for other models from MGE, but this implementation assumes a single phase/single receptacle unit (i.e. it only looks at the first entry in tables that index on phases or receptacles) and has only been tested on an EXL5 UPS.)

Paul Wefel from NCSA at UIUC sends a probe that monitors an Emerson -48v DC system current and voltage Uninterruptible Power Supply (UPS). If the Emerson is running on battery, we need to know when the system voltage is about to fall below the system cutoff value. The probe also allows us to baseline current consumption and alert if there is a change indicating a possible failure in the active...

Steven Matkoski from NYSERNet, Inc. in Syracuse, NY sends a probe for the Emerson/Marconi LMS1000 Uninterruptible Power Supply (UPS). It reads the voltage and amperage of the device, and alerts at certain thresholds. Steven writes, "We had absolutely no ability to monitor these devices. With this probe, the UPS fits nicely into our remote-site management."

Monitors an MGE EPC 6000 UPS with a UM-Link Ethernet interface, including phases B and C.

Monitors a BestPower Uninterruptible Power Supply (UPS).