Reports status conditions for APC Silcon UPS. It's geared for a three-module N+1 setup on 208v power, and warns about load when you are in danger of going out of redundancy (as opposed to reaching the one-module tolerances), but the thresholds are fully adjustable.

Monitors 3-phase APC rack-mount PDUs. The probe checks all three phases for load plus current for each of the individual phases. Warning, alarm and critical thresholds can be set for current.

Monitors the temperature, humidity, and airflow of a Netbotz 320 device. It will also alert when the camera motion sensor goes off.

Ilias Manos from Piraeus Port Authority in Piraeus, Greece sends a probe that monitors the temperature, humidity, water and open door of a APC Netbotz 200. Ilias writes, "We needed a software to monitor the temperature, humidity, water and open door of racks with Netbotz. Intermapper Probe Cost = Free."

Monitors an MGE "UM-Sensor" environmental sensor with a UM-Link Ethernet interface via SNMP. The probe can be used as a starting point for the design of similar probes, but this implementation assumes a single UM-Sensor (up to 4 could be daisy-chained) on the assigned comm port of the UM-Link interface (i.e. it only looks at the first entry in table that indexes sensor units).

Monitors the conditions (temperature and relative humidity) from an APC environmental monitoring card.

Monitors the temperature and relative humidity of an APC Environmental Monitor. This probe can monitor the values of up to two APC probes.

Monitors temperature and humidity for the APC AP9230 Environmental Monitoring System and alarms when thresholds are exceeded.